Meta AR/VR Job | DFx Manufacturing Engineer | Oculus
Job（岗位）: DFx Manufacturing Engineer | Oculus
Type（岗位类型）: Hardware | Operations, Partner Engineering, Partnerships, Product Strategy, Program Management
Citys（岗位城市）: Sunnyvale, CA | Redmond, WA | Seattle, WA
Date（发布日期）: 2022-2-16
Summary（岗位介绍）
As a member of the DFx (design for manufacturing) team, you will have a direct impact in creating solutions for complex problems that impact quality, cost, and delivery of future AR/VR, wearable and portal product families. You will define and implement best practices to meet the manufacturing challenges of our next generation of products. As a key member of the Technical Operations team, you will partner closely with cross functional teams (Hardware Engineering, Quality, Test, and Manufacturing Partners) to ensure designs are manufacturable from concept to high volume mass production.
Qualifications（岗位要求）
BS in Mechanical Engineering or related field
3+ years experience in mechanical product design and/or manufacturing
Experience with mass production of hardware products or related experience
Description（岗位职责）
Partner with cross functional teams to identify and resolve manufacturing challenges by following DFx best practices and principles.
Conduct detailed CAD reviews to identify manufacturing pain points and design alternatives.
Identify NTI (New Technology Introduction) manufacturing processes.
Define manufacturing processes and equipment requirements at the factory.
Provide direction, guidance, and support to other engineering groups and CM partners.
Develop new and improved manufacturing methods through application of theoretical and practical engineering.
Synthesizing complex data sets into actionable feedback and lessons learned.
Drive all FATP line qualifications activities.
Willingness to travel domestically and internationally.
Additional Requirements（额外要求）
MS Mechanical Engineering or Equivalent.
Experience in consumer electronics.
Advanced CAD Experience (NX Preferred).
Experience understanding and challenging tolerance stackups to meet gap/step requirements.
Working knowledge of GD&T.
Knowledge of optical alignment and qualification procedures.
Optical component and metrology experience.
Experience working with overseas vendors.
Six Sigma/DMAIC training.
JMP/Minitab competency.
Clean room experience.
Experience in advanced analysis & problem-solving techniques including DOE, failure analysis, CpK, GR&R, PFMEA etc.
Experience in production line development techniques including flow chart, cycle time calculation, UPH setup, line layout & balance, SOP, etc.
Experience in AR/VR hardware development.
